3.2.1 Ensure source routed packets are not accepted - sysctl net.ipv6.conf.default.accept_source_route=0

Information

In networking, source routing allows a sender to partially or fully specify the route packets take through a network. In contrast, non-source routed packets travel a path determined by routers in the network. In some cases, systems may not be routable or reachable from some locations (e.g. private addresses vs. Internet routable), and so source routed packets would need to be used.

Rationale:

Setting net.ipv4.conf.all.accept_source_route, net.ipv4.conf.default.accept_source_route, net.ipv6.conf.all.accept_source_route and net.ipv6.conf.default.accept_source_route to 0 disables the system from accepting source routed packets. Assume this system was capable of routing packets to Internet routable addresses on one interface and private addresses on another interface. Assume that the private addresses were not routable to the Internet routable addresses and vice versa. Under normal routing circumstances, an attacker from the Internet routable addresses could not use the system as a way to reach the private address systems. If, however, source routed packets were allowed, they could be used to gain access to the private address systems as the route could be specified, rather than rely on routing protocols that did not allow this routing.

Solution

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file:

net.ipv4.conf.all.accept_source_route = 0
net.ipv4.conf.default.accept_source_route = 0
net.ipv6.conf.all.accept_source_route = 0
net.ipv6.conf.default.accept_source_route = 0

Run the following commands to set the active kernel parameters:

# sysctl -w net.ipv4.conf.all.accept_source_route=0
# sysctl -w net.ipv4.conf.default.accept_source_route=0
# sysctl -w net.ipv6.conf.all.accept_source_route=0
# sysctl -w net.ipv6.conf.default.accept_source_route=0
# sysctl -w net.ipv4.route.flush=1
# sysctl -w net.ipv6.route.flush=1




Notes:

This Benchmark recommendation maps to:

Red Hat Enterprise Linux 7 Security Technical Implementation Guide:

Version 2, Release: 3 Benchmark Date: 26 Apr 2019



Vul ID: V-72283

Rule ID: SV-86907r2_rule

STIG ID: RHEL-07-040610

Severity: CAT II



Vul ID: V-72285

Rule ID: SV-86909r2_rule

STIG ID: RHEL-07-040620

Severity: CAT II



Vul ID: V-72319

Rule ID: SV-86943r2_rule

STIG ID: RHEL-07-040830

Severity: CAT II

See Also

https://workbench.cisecurity.org/files/2688

Item Details

Category: CONFIGURATION MANAGEMENT

References: 800-53|CM-6, CSCv7|5.1

Plugin: Unix

Control ID: 53f499546c970067907b7d08fd6ec369190079e43e93bd60f19831b2b17795c0