Detections
Analytics
2.3.9.5 (L1) Ensure 'Microsoft network server: Server SPN target name validation level' is set to 'Accept if provided by client' or higher (MS only)
Information
This policy setting controls the level of validation a computer with shared folders or printers (the server) performs on the service principal name (SPN) that is provided by the client computer when it establishes a session using the server message block (SMB) protocol.The server message block (SMB) protocol provides the basis for file and print sharing and other networking operations, such as remote Windows administration. The SMB protocol supports validating the SMB server service principal name (SPN) within the authentication blob provided by a SMB client to prevent a class of attacks against SMB servers referred to as SMB relay attacks. This setting will affect both SMB1 and SMB2.
The recommended state for this setting is: Accept if provided by client Configuring this setting to Required from client also conforms to the benchmark.
Note: Since the release of the MS
KB3161561
security patch, this setting can cause significant issues (such as replication problems, group policy editing issues and blue screen crashes) on Domain Controllers when used
simultaneously
with UNC path hardening (i.e. Rule 18.5.14.1). CIS therefore recommends against deploying this setting on Domain Controllers.
The identity of a computer can be spoofed to gain unauthorized access to network resources.
Solution
To establish the recommended configuration via GP, set the following UI path to Accept if provided by client (configuring to Required from client also conforms to the benchmark):Computer Configuration\Policies\Windows Settings\Security Settings\Local Policies\Security Options\Microsoft network server: Server SPN target name validation level
Impact:
All Windows operating systems support both a client-side SMB component and a server-side SMB component. This setting affects the server SMB behavior, and its implementation should be carefully evaluated and tested to prevent disruptions to file and print serving capabilities.
If configured to Accept if provided by client the SMB server will accept and validate the SPN provided by the SMB client and allow a session to be established if it matches the SMB server's list of SPN's for itself. If the SPN does NOT match, the session request for that SMB client will be denied.
If configured to Required from client the SMB client MUST send a SPN name in session setup, and the SPN name provided MUST match the SMB server that is being requested to establish a connection. If no SPN is provided by client, or the SPN provided does not match, the session is denied.
See Also
Item Details
Category: CONFIGURATION MANAGEMENT
References: 800-53|CM-6b.
Plugin: Windows
Control ID: 638f8e489f34a20c16f51f6ac7460cb099f30375fad33e38a637aa42c1b417b7