ARST-L2-000130 - The Arista MLS layer 2 switch must have IGMP or MLD Snooping configured on all VLANs.

Information

IGMP and MLD snooping provides a way to constrain multicast traffic at Layer 2. By monitoring the IGMP or MLD membership reports sent by hosts within a VLAN, the snooping application can set up Layer 2 multicast forwarding tables to deliver specific multicast traffic only to interfaces connected to hosts interested in receiving the traffic, thereby significantly reducing the volume of multicast traffic that would otherwise flood the VLAN.

Solution

Configure the Arista MLS switch for IGMP snooping for IPv4 and IPv6 multicast traffic for each VLAN.

Configure the Arista MLS switch for IP PIM, which also enables IGMP on an Arista MLS switch VLAN or interface, by using the following command:

switch(config)#int vlan8
ip igmp
pim ipv4 sparse-mode
pim ipv6 sparse-mode
switch(config)#exit
!

Arista MLS switch alternative configuration for MLD snooping on an interface for version 1 and 2. Version 2 is the default MLD version.

switch(config)# mld snooping
switch(config-mld-snooping)# vlan 200
!

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Arista_MLS_EOS_4-2x_Y24M07_STIG.zip

Item Details

Category: CONFIGURATION MANAGEMENT

References: 800-53|CM-6b., CAT|III, CCI|CCI-000366, Rule-ID|SV-255976r882270_rule, STIG-ID|ARST-L2-000130, Vuln-ID|V-255976

Plugin: Arista

Control ID: 6582d5c10dd2a4507dcdc071df92f2829d62ebe5480577b746407cf344ab4606