ARST-RT-000130 - The Arista multicast router must be configured to bind a Protocol Independent Multicast (PIM) neighbor filter to interfaces that have PIM enabled.

Information

PIM is a routing protocol used to build multicast distribution trees for forwarding multicast traffic across the network infrastructure. PIM traffic must be limited to only known PIM neighbors by configuring and binding a PIM neighbor filter to those interfaces that have PIM enabled. If a PIM neighbor filter is not applied to those interfaces that have PIM enabled, unauthorized routers can join the PIM domain, discover and use the rendezvous points, and also advertise their rendezvous points into the domain. This can result in a denial of service by traffic flooding or result in the unauthorized transfer of data.

NOTE: Nessus has provided the target output to assist in reviewing the benchmark to ensure target compliance.

Solution

This requirement is not applicable for the DODIN backbone.

Configure neighbor filters to only accept PIM control plane traffic from documented PIM neighbors. Bind neighbor filters to all PIM-enabled interfaces.

Step 1: Configure an ACL that will specify the authorized PIM neighbors.

router(config)#ip access-list standard filter_1
router(config-std-acl-filter_1)#permit 10.13.24.9/24
router(config-std-acl-filter_1)#exit

Step 2: Configure a PIM neighbor-filter command and apply it on all PIM-enabled interfaces that are referencing the PIM neighbor ACL.

router(config)#interface vlan 4
router(config-if-Vl4)#pim ipv4 neighbor-filter filter_1
router(config-if-Vl4)#exit

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Arista_MLS_EOS_4-2x_Y24M07_STIG.zip

Item Details

Category: ACCESS CONTROL

References: 800-53|AC-4, CAT|II, CCI|CCI-001414, Rule-ID|SV-255999r882339_rule, STIG-ID|ARST-RT-000130, Vuln-ID|V-255999

Plugin: Arista

Control ID: 185cc1c4497a8ade01a7e687d44a930d22546d46ecd07c07a0c5d98bb71cb5b5