CISC-RT-000397 - The Cisco perimeter router must be configured to drop IPv6 packets containing the NSAP address option within Destination Option header.

Information

The optional and extensible natures of the IPv6 extension headers require higher scrutiny since many implementations do not always drop packets with headers that it cannot recognize, and hence could cause a Denial-of-Service on the target device. In addition, the type, length, value (TLV) formatting provides the ability for headers to be very large. This option type from RFC 1888 (OSI NSAPs and IPv6) has been deprecated by RFC 4048.

Solution

Configure the router to to drop IPv6 packets containing the NSAP address option within Destination Option header as shown in the example below.

R1(config)#ipv6 access-list FILTER_IPV6
R1(config-ipv6-acl)#deny 60 any any dest-option-type 195 log
R1(config-ipv6-acl)#permit ...
...
...
...
R1(config-ipv6-acl)# deny ipv6 any any log
R1(config-ipv6-acl)#exit
R1(config)#int g1/0
R1(config-if)#ipv6 traffic-filter FILTER_IPV6
R1(config-if)#end

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Cisco_IOS-XE_Router_Y24M07_STIG.zip

Item Details

Category: SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|SC-7(11), CAT|II, CCI|CCI-002403, Rule-ID|SV-230156r855850_rule, STIG-ID|CISC-RT-000397, Vuln-ID|V-230156

Plugin: Cisco

Control ID: 46cb3770d0fc87809f253066d2c762c8b307a09561ef78d0e07950b52cf9c5ea