CISC-L2-000200 - The Cisco switch must have all trunk links enabled statically.

Information

When trunk negotiation is enabled via Dynamic Trunk Protocol (DTP), considerable time can be spent negotiating trunk settings (802.1q or ISL) when a node or interface is restored. While this negotiation is happening, traffic is dropped because the link is up from a layer 2 perspective. Packet loss can be eliminated by setting the interface statically to trunk mode, thereby avoiding dynamic trunk protocol negotiation and significantly reducing any outage when restoring a failed link or switch.

NOTE: Nessus has provided the target output to assist in reviewing the benchmark to ensure target compliance.

Solution

Configure the switch to enable trunk links statically as shown in the configuration below:

SW2(config-if)#switchport trunk encapsulation dot1q
SW2(config-if)#switchport mode trunk
SW2(config-if)#switchport nonegotiate

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Cisco_IOS-XE_Switch_Y24M07_STIG.zip

Item Details

Category: CONFIGURATION MANAGEMENT

References: 800-53|CM-6b., CAT|II, CCI|CCI-000366, Rule-ID|SV-220666r539671_rule, STIG-ID|CISC-L2-000200, STIG-Legacy|SV-110307, STIG-Legacy|V-101203, Vuln-ID|V-220666

Plugin: Cisco

Control ID: a57db65f698ad8261adba259a0da8052ab2788ea90b1455fa5c17b658117e90e