Information
Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that register messages are accepted only for authorized multicast groups and sources.
Solution
Configure the switch to filter PIM register messages received from a multicast DR for any undesirable multicast groups and sources. The example below will deny any multicast streams for groups 239.5.0.0/16 and allow from only sources x.1.2.6 and x.1.2.7.
Step 1: Configure a route map to filter multicast groups and sources as shown in the example below:
SW1(config)# route-map PIM_REGISTER_FILTER deny 10
SW1(config-route-map)# match ip multicast group 239.5.0.0/16
SW1(config-route-map)# route-map PIM_REGISTER_FILTER permit 20
SW1(config-route-map)# match ip multicast source x.1.2.6/32
SW1(config-route-map)# route-map PIM_REGISTER_FILTER permit 30
SW1(config-route-map)# match ip multicast source x.1.2.7/32
SW1(config-route-map)# route-map PIM_REGISTER_FILTER permit 40
SW1(config-route-map)# match ip multicast group-range 232.0.0.0 to 233.255.255.255
SW1(config-route-map)# route-map PIM_REGISTER_FILTER deny 50
SW1(config-route-map)# match ip multicast source 0.0.0.0/0
SW1(config-route-map)# exit
Step 2: Configure a multicast register policy referencing the configured route map.
SW1(config)# ip pim register-policy PIM_REGISTER_FILTER
SW1(config)# end