Detections
Analytics

CISC-RT-000610 - The MPLS switch with RSVP-TE enabled must be configured with message pacing to adjust maximum burst and maximum number of RSVP messages to an output queue based on the link speed and input queue size of adjacent core switches.

Warning! Audit Deprecated

This audit has been deprecated and will be removed in a future update.

View Next Audit Version

Information

RSVP-TE can be used to perform constraint-based routing when building LSP tunnels within the network core that will support QoS and traffic engineering requirements. RSVP-TE is also used to enable MPLS Fast Reroute, a network restoration mechanism that will reroute traffic onto a backup LSP in case of a node or link failure along the primary path. When there is a disruption in the MPLS core, such as a link flap or switch reboot, the result is a significant amount of RSVP signaling, such as 'PathErr' and 'ResvErr' messages that need to be sent for every LSP using that link.

When RSVP messages are sent out, they are sent either hop by hop or with the switch alert bit set in the IP header. This means that every switch along the path must examine the packet to determine if additional processing is required for these RSVP messages. If there is enough signaling traffic in the network, it is possible for an interface to receive more packets for its input queue than it can hold, resulting in dropped RSVP messages and hence slower RSVP convergence. Increasing the size of the interface input queue can help prevent dropping packets; however, there is still the risk of having a burst of signaling traffic that can fill the queue. Solutions to mitigate this risk are RSVP message pacing or refresh reduction to control the rate at which RSVP messages are sent. RSVP refresh reduction includes the following features: RSVP message bundling, RSVP Message ID to reduce message processing overhead, reliable delivery of RSVP messages using Message ID, and summary refresh to reduce the amount of information transmitted every refresh interval.

Solution

Configure the switch to rate limit RSVP messages per interface as shown in the example below. Configure the MPLS switch to synchronize IGP and LDP, minimizing packet loss when an IGP adjacency is established prior to LDP peers completing label exchange.

OSPF Example

SW1(config)# router ospf 1
SW1(config-switch)# mpls ldp sync

IS-IS Example

SW1(config)# router isis
SW1(config-switch)# mpls ldp sync.

SW1(config)# ip rsvp
SW1(config-ip-rsvp)# signaling refresh reduction
SW1(config-ip-rsvp)# end

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Cisco_NX-OS_Switch_Y24M04_STIG.zip

Item Details

References: CAT|III, CCI|CCI-001095, Rule-ID|SV-221115r622190_rule, STIG-ID|CISC-RT-000610, STIG-Legacy|SV-111049, STIG-Legacy|V-101945, Vuln-ID|V-221115

Plugin: Cisco

Control ID: b42759d7f365d49dffeb224ef93ea0c8bbf6ee5139ee489b749c8ef458917604