Detections
Analytics
JUNI-RT-000450 - The Juniper router providing connectivity to the NOC must be configured to forward all in-band management traffic via an IPsec tunnel - Mgmt
Information
When the production network is managed in-band, the management network could be housed at a NOC that is located remotely at single or multiple interconnected sites. NOC interconnectivity, as well as connectivity between the NOC and the managed network, must be enabled using IPsec tunnels to provide the separation and integrity of the managed traffic.Solution
This requirement is not applicable for the DoDIN Backbone.Ensure that all traffic from the managed network to the management network is secured via IPsec tunnel as shown in the configuration examples below.
Configure an IPsec tunnel to be used to transport the management traffic.
[edit security]
set ike proposal IKE_PHASE1_PROPOSAL authentication-method pre-shared-keys
set ike proposal IKE_PHASE1_PROPOSAL authentication-algorithm sha-256
set ike proposal IKE_PHASE1_PROPOSAL dh-group group14
set ike proposal IKE_PHASE1_PROPOSAL encryption-algorithm aes-128-cbc
set ike policy 10.1.25.2 proposals IKE_PHASE1_PROPOSAL
set ike policy 10.1.25.2 mode main
set ike policy 10.1.25.2 pre-shared-key ascii-text xxxxxxxxx
set ipsec proposal IPSEC_PHASE2_PROPOSAL protocol esp
set ipsec proposal IPSEC_PHASE2_PROPOSAL authentication-algorithm hmac-sha1-96
set ipsec proposal IPSEC_PHASE2_PROPOSAL encryption-algorithm aes-128-cbc
set policy IPSEC_POLICY perfect-forward-secrecy keys group14
set policy IPSEC_POLICY proposals xxxxx
set ipsec security-association IPSEC_SA_MGMT mode tunnel
set ipsec security-association IPSEC_SA_MGMT dynamic ipsec-policy IPSEC_POLICY
Configure a filter that will select which traffic to be forwarded via the IPsec tunnel by specifying the security association bound to the tunnel.
[edit firewall family inet]
set filter MGMT_TRAFFIC term ALLOW_SNMP from protocol udp port [snmp snmptrap]
set filter MGMT_TRAFFIC term ALLOW_SNMP then ipsec-sa IPSEC_SA_MGMT
set filter MGMT_TRAFFIC term ALLOW_TACACS from protocol tcp port tacacs
set filter MGMT_TRAFFIC term ALLOW_TACACS then ipsec-sa IPSEC_SA_MGMT
set filter MGMT_TRAFFIC term ALLOW_NETFLOW from protocol udp port [2055 9995 9996]
set filter MGMT_TRAFFIC term ALLOW_NETFLOW then ipsec-sa IPSEC_SA_MGMT
set filter MGMT_TRAFFIC term OTHER then accept
See Also
https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Juniper_Router_Y24M07_STIG.zip
Item Details
Audit Name: DISA STIG Juniper Router RTR v3r1
Category: SYSTEM AND COMMUNICATIONS PROTECTION
References: 800-53|SC-7a., CAT|II, CCI|CCI-001097, Rule-ID|SV-217050r604135_rule, STIG-ID|JUNI-RT-000450, STIG-Legacy|SV-101095, STIG-Legacy|V-90885, Vuln-ID|V-217050
Plugin: Juniper
Control ID: 082684090905aae7074d4860f48625c44f133b503d624788a533f701c0971259