JUNI-RT-000370 - The Juniper perimeter router must be configured to have Proxy ARP disabled on all external interfaces.

Information

When Proxy ARP is enabled on a router, it allows that router to extend the network (at Layer 2) across multiple interfaces (LAN segments). Because proxy ARP allows hosts from different LAN segments to look like they are on the same segment, proxy ARP is only safe when used between trusted LAN segments. Attackers can leverage the trusting nature of proxy ARP by spoofing a trusted host and then intercepting packets. Proxy ARP should always be disabled on router interfaces that do not require it, unless the router is being used as a LAN bridge.

NOTE: Nessus has provided the target output to assist in reviewing the benchmark to ensure target compliance.

Solution

This requirement is not applicable for the DoDIN Backbone.

Disable Proxy ARP on all external interfaces as shown in the example below.

[edit interfaces em0 unit 0]
delete proxy-arp restricted

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Juniper_Router_Y24M07_STIG.zip

Item Details

Category: SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|SC-7(11), CAT|II, CCI|CCI-002403, Rule-ID|SV-217042r855897_rule, STIG-ID|JUNI-RT-000370, STIG-Legacy|SV-101079, STIG-Legacy|V-90869, Vuln-ID|V-217042

Plugin: Juniper

Control ID: 1512f7da6c5217440169121e4c7173de8d95a869234e60cb5d369325f84bdf46