JUSX-AG-000124 - The Juniper SRX Services Gateway Firewall must block outbound traffic containing known and unknown denial-of-service (DoS) attacks to protect against the use of internal information systems to launch any DoS attacks against other networks or endpoints - DoS attacks against other networks or endpoints.

Information

DoS attacks can take multiple forms but have the common objective of overloading or blocking a network or host to deny or seriously degrade performance. If the network does not provide safeguards against DoS attack, network resources will be unavailable to users. The Juniper SRX must include protection against DoS attacks that originate from inside the enclave, which can affect either internal or external systems. These attacks may use legitimate or rogue endpoints from inside the enclave. These attacks can be simple 'floods' of traffic to saturate circuits or devices, malware that consumes CPU and memory on a device or causes it to crash, or a configuration issue that disables or impairs the proper function of a device. For example, an accidental or deliberate misconfiguration of a routing table can misdirect traffic for multiple networks.

The Juniper SRX Firewall uses Screens and Security Policies to detect known DoS attacks with known attack vectors. However, these Screens and policies must be applied to outbound traffic using zones and interface stanzas.

Traffic exits the Juniper SRX by way of interfaces. Security zones are configured for one or more interfaces with the same security requirements for filtering data packets. A security zone implements a security policy for one or multiple network segments. These policies must be applied to inbound traffic as it crosses both the network perimeter and as it crosses internal security domain boundaries.

NOTE: Nessus has provided the target output to assist in reviewing the benchmark to ensure target compliance.

Solution

To enable screen protection, the screen profile must be associated with individual security zones using the following command. Recommend assigning 'untrust-screen' profile name.

Apply screen to each outbound interface example:

set security zones security-zone untrust interfaces <OUTBOUND-INTERFACE>
set security zones security-zone trust screen untrust-screen

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Juniper_SRX_SG_Y24M07_STIG.zip

Item Details

Category: SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|SC-5(1), CAT|II, CCI|CCI-001094, CCI|CCI-004866, Rule-ID|SV-214532r997549_rule, STIG-ID|JUSX-AG-000124, STIG-Legacy|SV-80819, STIG-Legacy|V-66329, Vuln-ID|V-214532

Plugin: Juniper

Control ID: 701c9b1ec11d8eb745dde1aeb43196e822133d83181788b3ae243f5c997fe4b7