EX13-MB-000210 - The Exchange Send connector connections count must be limited.

Information

The Exchange Send connector setting controls the maximum number of simultaneous outbound connections allowed for a given SMTP connector and can be used to throttle the SMTP service if resource constraints warrant it. If the limit is too low, connections may be dropped. If too high, some domains may use a disproportionate resource share, denying access to other domains. Appropriate tuning reduces risk of data delay or loss.

Solution

Update the EDSP.

Open the Exchange Management Shell and enter the following command:

Set-TransportServer -Identity <'IdentityName'> -MaxOutboundConnections 1000

Note: The <IdentityName> value must be in quotes.

or

The value as identified by the EDSP that has obtained a signoff with risk acceptance.

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_MS_Exchange_2013_Y24M07_STIG.zip

Item Details

Category: SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|SC-5(2), CAT|III, CCI|CCI-001095, Rule-ID|SV-207308r961155_rule, STIG-ID|EX13-MB-000210, STIG-Legacy|SV-84645, STIG-Legacy|V-70023, Vuln-ID|V-207308

Plugin: Windows

Control ID: 10db52d935c8af4038a87cb6d1e04ab84c81fa7cfd25d050be1123120eeb9940