SPLK-CL-000390 - Splunk Enterprise must be installed in FIPS mode to implement NIST FIPS-approved cryptography for all cryptographic functions.

Information

FIPS 140-2 precludes the use of unvalidated cryptography for the cryptographic protection of sensitive or valuable data within Federal systems. Unvalidated cryptography is viewed by NIST as providing no protection to the information or data. In effect, the data would be considered unprotected plaintext. If the agency specifies that the information or data be cryptographically protected, then FIPS 140-2 is applicable. In essence, if cryptography is required, it must be validated. Cryptographic modules that have been approved for classified use may be used in lieu of modules that have been validated against the FIPS 140-2 standard.

Satisfies: SRG-APP-000172-AU-002550, SRG-APP-000179-AU-002670, SRG-APP-000514-AU-002890

NOTE: Nessus has not performed this check. Please review the benchmark to ensure target compliance.

Solution

FIPS 140-2 mode must be enabled during initial installation. If not enabled, it requires a reinstall or upgrade of the application.

Add the following line to the $SPLUNK_HOME/etc/splunk-launch.conf file during the installation process and before the initial start of Splunk Enterprise:

SPLUNK_COMMON_CRITERIA=1
SPLUNK_FIPS=1
# Do not generate python byte code
PYTHONDONTWRITEBYTECODE=1

This will enable FIPS mode before the initial startup.

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Splunk_Enterprise_8-x_for_Linux_V2R1_STIG.zip

Item Details

Category: IDENTIFICATION AND AUTHENTICATION, SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|IA-5(1)(c), 800-53|IA-7, 800-53|SC-13, CAT|I, CCI|CCI-000197, CCI|CCI-000803, CCI|CCI-002450, Rule-ID|SV-251686r961029_rule, STIG-ID|SPLK-CL-000390, Vuln-ID|V-251686

Plugin: Splunk

Control ID: 274d7d29dfb47ca01277e82bad57a04ec409b7bcb603cfa8f4f95243a6669e6a